科研之友
微信
新浪微博
Facebook
分享链接
摘要
In a conventional reservoir simulation, analytical well models relate well block pressure, wellbore pressure, fluid mobility, and geometric factors such as wellbore radius and grid size. Basically, fluid viscosity is assumed to be Newtonian in these models. Commercial reservoir simulators using these well models often predict unrealistic well injectivity in simulation of processes involving non-Newtonian fluids such as polymer solutions. Apparent viscosity of a polymer solution is a complicated function of flow velocity, polymer properties, permeability, porosity, salinity, etc. As the distance away from an injection well increases, flow velocity decreases; meanwhile, the apparent polymer viscosity changes drastically. For shear-thinning polymers, the average flow velocity in a well block is several orders of magnitude smaller than the flow velocity near the wellbore, especially when grid size is large. Using the average flow velocity for apparent viscosity calculation leads to an underestimate of well injectivity. Thus it is crucial to consider non-Newtonian effects in simulation of injectivity of polymer solutions. UTCHEM, a general purpose chemical flooding simulator developed at the University of Texas, uses a semianalytical polymer injectivity model based on an extension of Peaceman's well model to non-Newtonian fluids. This model corrects the apparent viscosity in well index calculation and gives a more realistic estimate of polymer injectivity. However, the model needs to be programmed and implemented in a code. It is not practical for users of commercial simulators which do not have semi-analytical polymer injectivity model. Compared with UTCHEM, CMG-STARS, the thermal and advanced processes reservoir simulator developed by Computer Modeling Group, uses an apparent skin factor to account for non-Newtonian effects of power law fluids. The apparent skin factor can be used as an input parameter to the simulator. In this study, we revisited the analytical polymer injectivity model and proposed a general form for the calculation of apparent skin factor. The apparent skin factor is estimated using polymer rheological properties, grid size, wellbore radius, etc., and can apply to any polymer rheology. Simulation studies of polymer flooding cases were conducted to verify the concept of apparent skin factor. The results show that for shear-thinning polymers, the apparent skin factor can be estimated properly and correct the analytical well model to give close predictions compared to the semi-analytical polymer injectivity model and fine-grid simulation. The concept of apparent skin factor was proved to be useful for improving the accuracy of well injectivity calculations by commercial simulators. However, it is also worth pointing out that the apparent skin factor cannot be used for polymers which show shear-thickening behavior at high shear rates for cases of heterogeneous reservoir.
- 出版日期2017-9
