Hybrid materials design to control creep in metallic pipes

作者：Reyngoud B P; Bishop C M; Kral M V^*

来源：Materials and Design, 2015, 84: 25-35.

DOI：10.1016/j.matdes.2015.06.089

• Hybrid
• Creep
• Architectured reinforcement
• Neutral angle

A hybrid material has been developed to improve creep performance in pressurized metallic pipes subjected to high-temperatures. Model materials were selected for an investigation of reinforcement design parameters in architectured materials. Brass pipes (65 wt.% Cu/35 wt.% Zn) with austenitic stainless steel reinforcement were pressurized and creep rupture tested at 673 K. Compared to unreinforced pipes of equal dimensions, a 47-times reduction in the effective strain rate was observed with a 50 degrees reinforcement angle. A 'neutral angle' of 54.7 +/- 1.5 degrees was determined experimentally, where tangential (hoop) and longitudinal stresses on the pipe can be balanced and strains minimized. For initial angles below the neutral angle, creep strain was shown to facilitate a shift in orientation towards the neutral angle. For an initial angle of 42 degrees, this shift towards the neutral angle resulted in instantaneous creep rate dropping from 170% of the mean creep rate to 60% of the mean creep rate over 820 h, when the final angle was measured to be 50 degrees. A high-temperature prototype (tungsten braid oriented at 53 degrees over a 253MA stainless steel pipe) was shown to give a creep life extension in excess of 300-times at 1313 K.

• 出版日期2015-11-4