Effect of different nanoparticles on HDPE UV stability

作者：Grigoriadou I; Paraskevopoulos K M; Chrissafis K; Pavlidou E; Stamkopoulos T G; Bikiaris D^*

来源：Polymer Degradation and Stability, 2011, 96(1): 151-163.

DOI：10.1016/j.polymdegradstab.2010.10.001

• Polyethylene
• Nanocomposites
• Nanoparticles
• UV stability

In the present study different series of HDPE nanocomposites were prepared by melt mixing on a Haake-Buchler Reomixer, containing 2.5 wt% of multiwall carbon nanotubes, pristine and modified montmorillonite, and SiO(2) nanoparticles. Nanocomposites in the form of thin films were exposed to UV irradiation at 280 nm at constant temperature (25 degrees C) and constant relative humidity (50%) for several times. From tensile strength and Young's Modulus measurements it was verified a high increase with initial UV irradiation times (till 100 h) and a slight reduction thereafter. The increase was higher in nanocomposites compared with neat HDPE, except these containing MWCNTs, and was attributed to the crystallinity increase in the particular samples. The mechanical properties reduction at higher UV irradiation times was attributed to the extensive macromolecular chain scission causing irregularities and holes in film surfaces. However, from FTIR study it was found that SiO(2) and organically modified montmorillonite cause a serious effect on HDPE during UV degradation. New chemical compounds containing carbonyl, vinyl and hydroxyl groups were formed. It seems that these nanoparticles have an accelerating effect acting as catalysts to HDPE photo-oxidation. This was also verified from micro-Raman analysis. Untreated montmorillonite has also a small influencing effect while neat HDPE and nanocomposites containing multiwall carbon nanotubes have the highest UV stability.

• 出版日期2011-1