Measurements of the purge helium pressure drop across pebble beds packed with lithium orthosilicate and glass pebbles

作者：Abou Sena Ali^*; Arbeiter Frederik; Boccaccini Lorenzo V; Schlindwein Georg

来源：Fusion Engineering and Design, 2014, 89(7-8): 1459-1463.

DOI：10.1016/j.fusengdes.2013.12.009

• Lithium orthosilicate
• Pressure drop
• Pebble bed
• Helium

The lithium orthosilicate pebble beds of the Helium Cooled Pebble Bed (HCPB) blanket are purged by helium to transport the produced tritium to the tritium extraction system. The pressure drop of the purge helium has a direct impact on the required pumping power and is a limiting factor for the purge mass flow. Therefore, the objective of this study is to measure the helium pressure drop across various HCPB-relevant pebble beds packed with lithium orthosilicate and glass pebbles. The pebble bed was formed by packing the pebbles into a stainless steel cylinder (ID=30 mm and L=120 mm); then it was integrated into a gas loop that has four variable-speed side-channel compressors to regulate the helium mass flow. The static pressure was measured at two locations (100 mm apart) along the pebble bed and at inlet and outlet of the pebble bed. The results demonstrated that: (i) the pressure drop significantly increases with decreasing the pebbles diameter, (ii) for the same superficial velocity, the pressure drop is directly proportional to the inlet pressure, and (iii) predictions of Ergun%26apos;s equation agree well with the experimental results. The measured pressure drop for the lithium orthosilicate pebble bed will support the design of the purge gas system for the HCPB.

• 出版日期2014-10