科研之友
微信
新浪微博
Facebook
分享链接
摘要
A systematic investigation on the morphology development of polyvinylidene fluoride hollow fiber membrane made using various N-methyl-2-pyrrolidone (NMP) aqueous solutions as an inner coagulant was carried out. The cross-sectional and inner surface morphology were analyzed with scanning electronic microscopy (SEM). It is found that with increase on NMP concentration, the morphology of the resultant membranes gradually shifted from a double-skin to a single-skin structure. When 40.0 similar to 55.0 wt.% NMP solution was used, some unexpected macrovoids near the inner region were observed. This special morphology feature was attributed to the reduced solidification rate of the inner surface as a result of increase on NMP concentration, which sharply weakened the inner skin strength. While the existence of centralized stress formed in the phase inversion process, such as shrinkage stress from syneresis, resulted in fractured points in the nascent skin surface that finally made it difficult to maintain a uniform structure. Investigations on effects of the dope flow rate and the bore fluid velocity on the morphology of PVDF fiber membranes experimentally confirmed the suggestion. Three model membranes with double skins, single skin and single skin with macrovoids structures, respectively, were used to test their permeation performance in a CO(2) membrane contactor system. The experimental results show the membranes without an inner skin present higher permeability and lower mass transfer resistance than the membrane with a double skin structure.
- 出版日期2011-2-5
- 单位南阳理工学院
