科研之友
微信
新浪微博
Facebook
分享链接
摘要
The aim of this study was to investigate the effects of plasma-enhanced deposition of an organosilane and benzene on resin bonding to a dental zirconia ceramic. A total of 70 zirconia specimens, which were polished before sintering, were randomly divided into five groups according to surface treatments before applying a dental adhesive (each group, n = 14): group 1, no previous treatment (control); group 2, plasma deposition with tetramethylsilane (TMS); group 3, plasma deposition with benzene; group 4, sequential plasma deposition with TMS and benzene; and group 5, a zirconia primer (Z-Prime Plus). A dental adhesive (Scotchbond Multi-Purpose adhesive) was applied to the surface-treated zirconia, and resin composite rods were built in to enable shear bond-strength testing. The sequential deposition of TMS and benzene showed the highest bond strength [22.7 +/- 3.7 MPa (mean +/- SD)], approximately twice that of Z-Prime Plus (10.3 +/- 3.2 MPa). The plasma deposition with either TMS or benzene also significantly improved bond-strength values compared with the negative-control group, and their effects were not statistically different from that of Z-Prime Plus. Following plasma deposition with TMS, the introduction of silicon-oxygen-zirconium (Si-O-Zr) bonds on the zirconia surface was confirmed via X-ray photoelectron spectroscopy (XPS) analysis. Transmission electron microscopy and energy dispersive X-ray spectroscopy showed that a silica-like layer and a polymerizable carbon-rich layer were formed through sequential deposition with TMS and benzene.
- 出版日期2017-2
