Preparation and Properties of Biodegradable Foams

作者：Stagner Jacqueline; Narayan Ramani^*

来源：Journal of Polymers and the Environment, 2011, 19(3): 598-606.

DOI：10.1007/s10924-011-0309-1

• Thermoplastic starch
• Foam
• Biodegradable
• PBAT

Foam extrusion of biodegradable polyester [poly(butylene adipate-co-terephthalate) (PBAT)] and its blends with maleated thermoplastic starch (MTPS) using a chemical blowing agent was performed. The effect of MTPS and percentage of chemical blowing agent on various foam properties is discussed. In general, an increased amount of PBAT in the foams improves the properties of the foams. The foam samples were characterized by measurements of density, expansion ratio, specific length, compressive strength, resiliency, moisture sorption, and imaging using digital light microscopy. Density, expansion ratio, and specific length measurements show that the best characteristics of lowest density, highest expansion ratio, and highest specific length are exhibited by the PBAT samples. The compressive strength and foam density exhibit a power-law relationship. Greater amounts of PBAT in the samples increase the resiliency and decrease the steady state weight gain during moisture sorption. All samples show regions of unfoamed material when only 3% chemical blowing agent is used, but when 5 and 7% chemical blowing agent is used, the samples exhibit cells throughout the matrix.

• 出版日期2011-9