科研之友
微信
新浪微博
Facebook
分享链接
摘要
Microstructure, hardness, precipitates and phase transformation on the X-Y surface of Inconel 718 Ni-based alloys fabricated by selective laser melting (SLM) were studied before and after a suitable heat treatment. The test results show that the obvious weld beads structure was observed on the surface of the as-built alloys, and the microstructure shows seriously inhomogeneous with distributing columnar crystals and fine dendrites. When the 720 degrees C, 3 h/furnace cooling + 620 degrees C and 3 h/air cooling was used, the columnar and small dendritic crystals begun to transform into bulk crystals, and the weld beads structure disappeared instantly. The X-Y surface hardness of alloys is about HV490-540, which is higher than the one of other heat treatment processes. With the increase of solid solution temperature, the microstructure on the surface of alloys shows an obvious refining characterization. The hardness value on the surface was also reduced gradually. The typical columnar crystals, dendrites, intermetallic compounds and precipitated hardening phase (Cr-Fe-Mo-Ni, FeNi and Ni8Nb) were also reduced or could not be found. Under the solid solution process of 950 degrees C, the fine homogeneous delta phase and gamma' phase in the grain or near the grain boundary had an important effect on the suitable surface hardness value (HV476-500) of alloys.
