Austenite and precipitation in secondary-hardening ultra-high-strength stainless steel

作者：Zhang, Yangpeng; Zhan, Dongping^*; Qi, Xiwei; Jiang, Zhouhua

来源：Materials Characterization, 2018, 144: 393-399.

DOI：10.1016/j.matchar.2018.07.038

• Secondary-hardening
• Ultra-high-strength stainless steel
• Austenite
• Precipitation
• M2C

Ferrium S53 is a new secondary-hardening ultra-high-strength stainless steel, with more Cr than other Co-Ni ultra-high-strength steels. Austenite has a great effect on the fracture toughness of this metal, and the carbides that are precipitated are the main strengthening phase of Ferrium S53 steel; in this study, its microstructural changes during heat treatment were observed and analyzed by X-ray diffraction (XRD), Optical microscope (OM), SEM, and transmission electron microscopy (TEM). About 40.85% retained austenite in the quenched sample is decreased to less than 5% after cryogenic treatment and tempering. In the final sample, block austenite is retained austenite, and film austenite around 5 nm in width is reverted austenite. Inside the martensite lath, parallel twin-like structures are actually segregated M2C precipitates, and most of them are smaller than 20 nm. These precipitates can be aggregated into a several-micron-long parallel zonal microstructure.

• 出版日期2018-10
• 单位东北大学