Development of microbubble generator for suppression of pressure waves in mercury target of spallation source

作者：Kogawa Hiroyuki^*; Naoe Takashi; Kyotoh Harumichi; Haga Katsuhiro; Kinoshita Hidetaka; Futakawa Masatoshi

来源：Journal of Nuclear Science and Technology, 2015, 52(12): 1461-1469.

DOI：10.1080/00223131.2015.1009188

• mercury target
• spallation neutron source
• pressure wave
• cavitation erosion
• microbubbles
• (multi) swirl-type bubble generator

A MW-class mercury target for the spallation neutron source is subjected to the pressure waves and cavitation erosion induced by high-intense pulsed-proton beam bombardment. Helium-gas microbubbles injection into mercury is one of the effective techniques to suppress the pressure waves. The microbubble injection technique was developed. The selection test of bubble generators indicated that the bubble generator utilizing swirl flow of liquid (swirl-type bubble-generator) will be suitable from the viewpoint of the produced bubble size. However, when single swirl-type bubble-generator was used in flowing mercury, swirl flow of mercury remains at downstream of the generator. The remaining swirl flow causes the coalescence of bubbles which results in ineffective suppression of pressure waves. To solve this concern, a multi-swirl type bubble-generator, which consists of several single swirl-type bubble-generators arraying in the plane perpendicular to mercury flow direction, was invented. The multi-swirl type bubble-generator was tested in mercury and the geometry was optimized to generate small bubble with low flow resistance based on the test results. It is estimated to generate the microbubbles of 65 m in radius under the operational condition of the Japanese Spallation Neutron Source mercury target, which is the sufficient size to suppress the pressure waves.

• 出版日期2015-12-2