Microstructure and superplasticity of TA15 alloy

作者：Sun, Q. J.^*; Wang, G. C.

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2014, 606: 401-408.

DOI：10.1016/j.msea.2014.03.117

• Microstructure
• Superplasticity
• TA15 alloy
• TEM

Superplasticity of TA15 alloy was investigated by constant strain rate tensile method in this work. In order to enhance superplasticity, thermo-mechanical techniques were applied for refining the grains of the alloy first. The superplastic tensile tests were carried out on a SANS CMT4104 electronic tensile testing machine at temperatures ranging from 780 to 950 degrees C and strain rates from 3.3 x 10(-4) to 1.1 x 10(-2) s(-1). The tensile elongation-to-failure values between 188% and 1074% were obtained. Microstructure evolution after superplastic deformation was also analyzed by optical microscope (OM) and transmission electron microscope (TEM). The micrographs show that the grains were coarsened after deformation, and a alpha ->beta phase transformation took place at 950 degrees C, which resulted in the worst superplasticity. Extensive strain hardening stages were observed in the true stress strain curves due to high dense dislocations in the thermo-mechanically processed alloy and dynamic grain growth during superplastic deformation. The strain rate sensitivity m and the activation energy values at various deformation conditions were calculated, respectively. Based on an analysis of the above studies, it may be inferred that grain boundary sliding (GBS) in TA15 alloy is accommodated by grain boundary diffusion at high temperatures and low strain rates, and the accommodation process involves dislocation glide creep at low temperatures and high strain rates.

• 出版日期2014-6-12
• 单位南昌航空大学