Analysis of the molecular weight distribution of vacuum residues and their molecular distillation fractions by laser desorption ionization mass spectrometry

作者：Palacio Lozano Diana Catalina; Armando Orrego Ruiz Jorge; Barrow Mark P; Cabanzo Hernandez Rafael; Mejia Ospino Enrique

来源：Fuel, 2016, 171: 247-252.

DOI：10.1016/j.fuel.2015.12.058

• Mass spectrometry
• Time-of-flight
• Vacuum residues
• Molecular distillation
• Partial least square

Average molecular weight analysis of vacuum residues using laser desorption ionization (LDI) can be a difficult task due to the significant influence of the experimental parameters and gas-phase reactions. In this paper, laser desorption/ionization time-of-flight mass spectrometry in reflectron mode (LDI TOF MS) was used to analyze vacuum residues and their molecular distillations (MD) fractions obtained at distillation cuts of 510-603 degrees C, 510-645 degrees C and 510-687 degrees C. Those samples associated with the lowest distillation temperature presented the narrowest molecular weight distributions and lowest average molecular weight (Mw) indicating lower complexity. American Petroleum Institute gravity, or API gravity (API degrees), is a measure of the weight of liquid petroleum compared to water, as expected a correlation between Mw and API degrees was determined, where lower API degrees correlated with higher molecular weight. When using higher laser energies mass spectra were acquired with a spacing of 24 Da between the peaks, indicating the production of carbon clusters or "fullerenes". This suggests that asphaltenes could be the precursors of the clusters that extend over 2500 Da in reflectron mode. Under appropriate experimental conditions, it was possible to produce repeatable molecular distribution for all the samples. Likewise, mass spectrometric data can be used in Principal Component Analysis (PCA) and Partial Least Square (PLS) analysis to discriminate and to predict density of the samples with low percentage of errors.

• 出版日期2016-5-1