科研之友
微信
新浪微博
Facebook
分享链接
摘要
The no-recrystallization temperature (T-nr) is an important parameter in the design of two-stage rolling schedule to obtain finer grain size. T-nr was obtained both by continuous cooling compression testing and tension-compression testing. However, due to the limitations of experimental installation, both compressing testing and tension-compression testing have a scaling down of practical pass strain and strain rate in rolling mill. The mathematical model that calculates mean flow stress (MFS) can eliminate these limitations and the pass strain and strain applied in mathematical model are approximately equal to the mean value of that in wire-rod rolling mill. Therefore, mathematical calculation is a new method to determine T-nr and the predicted T-nr is similar to experimental results. Due to the high strain rate and short interpass time at the finishing strain of wire rods mills, mathematical modeling is also an effective method to simulate microstructure-evolution in wire rods rolling. An expert system was established to study the microstructure evolution in two-stage rolling through the obtained dynamic recrystallization (DRX) model combined with metadynamic recrystallization (MRX) and static recrystallization (SRX) model in literature. In the present work, it is simplified that the complete metadynamic recrystallization (MRX) is achieved when strain for deformation exceeds critical strain epsilon(c). It was found that strain accumulation played an important role in finishing rolling. The recrystallization behavior during finishing rolling stage was repeated by static and dynamic model. The predicted austenite grain size and mean flow stress at each pass are expected to provide guidance for appropriate rolling schedule design.
- 出版日期2014-9
- 单位北京科技大学
