A model for volume fraction and/or particle size selection in metal matrix composites

作者：Kai, X. Z.; Li, Z. Q.^*; Zhang, W. L.; Fan, G. L.; Jiang, L.; Lu, W. J.; Zhang, D.

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2011, 530(1): 574-579.

DOI：10.1016/j.msea.2011.10.022

• f.c.c model
• Particle size selection
• Uniform distribution
• Metal matrix composites

In this study, a face-centered cubic (f.c.c) model for volume fraction and/or particle size selection in particle-reinforced metal matrix composites (PMMCs) via powder metallurgy (P/M) routes is presented to get a uniform distribution of reinforcements. The f.c.c model is an alternative to the cubic model proposed by Tan and Zhang [12] and its extension proposed by Reihanian et al. [14]. Uniform distribution criteria by the f.c.c model were proposed both for bi-modal and tri-modal composites obtained after different deformation processing, such as extrusion, rolling, high pressure torsion (HPT) and equal channel angular pressing (ECAP). Compared with the previous cubic models, the f.c.c model is applicable to a wider range of reinforcement volume fraction. Evaluation results both from some P/M PMMCs reported in literatures and the P/M B(4)C/AI composites fabricated in the present study, showed that the f.c.c model is more accurate to simulate and predict the actual reinforcement distributions.

• 出版日期2011-12-15
• 单位上海交通大学; 金属基复合材料国家重点实验室