Limit equilibrium slope stability analysis using the nonlinear strength failure criterion

作者：Deng, Dong-ping; Zhao, Lian-heng^*; Li, Liang

来源：Canadian Geotechnical Journal, 2015, 52(5): 563-576.

DOI：10.1139/cgj-2014-0111

• two- and three-dimensional slopes
• stability analysis
• limit equilibrium
• nonlinear strength failure criterion
• safety factor

The limit equilibrium stability analysis of two- and three-dimensional slopes with the nonlinear failure strength criterion uses a number of variables to determine the normal and shear stress on the slip surface. The equation for the nonlinear strength failure criterion is expressed using a Taylor series after analyzing the stress of an elemental slice or column. Multivariate linear equations are then derived to determine these variables based on the force and moment equilibrium conditions the sliding body is subject to. The stress on the slip surface can also be obtained to calculate the slope safety factor. The validity of the current method was verified by comparing it with established examples. Charts were produced for slope stability analysis with the nonlinear strength failure criterion under general conditions using the current method. The results of this study show that the slope safety factor decreases with an increase in the geotechnical material parameter m in the nonlinear strength failure criterion. The results of the current method are in close correspondence with other traditional limit equilibrium methods and are more reliable than the Swedish method. The charts can be used to determine slope design parameters that meet specific requirements.

• 出版日期2015-5
• 单位中南大学