科研之友
微信
新浪微博
Facebook
分享链接
摘要
Objective: The purpose of this retrospective radiographic study was to determine the reliability and reproducibility of skeletal and dental measurements of lateral cephalograms created from a computerised tomography (CT) scan compared with conventional and digital lateral cephalograms. %26lt;br%26gt;Methods: CT and conventional lateral cephalograms of the same patients were obtained from university archives. The lateral cephalometric radiographs of 30 patients were manually traced. The radiographs were subsequently scanned and traced using Dolphin Imaging software version 11 (Dolphin Imaging, Chatsworth, CA, USA). The CT-created lateral cephalograms were also traced using the same software. Sixteen (10 angular and 6 linear) measurements were performed. Cephalometric measurements obtained from conventional, digital and CT-created cephalograms were statistically compared using repeated measures analysis of variance (ANOVA). Statistical significance was set at the p %26lt; 0.05 level of confidence. %26lt;br%26gt;Results: The intro-rater reliability test for each method showed high values (r %26gt; 0.90) except for mandibular length which had a correlation of 0.82 for the CT-created cephalogram. Five measurements (N-A-Pog, N-S, ANS-PNS, Co-ANS and Co-Gn) were found to be significantly different between the CT-created and conventional cephalograms and three measurements (SNB, ANB, and /1-MP) were found to be significantly different between the CT-created and digital cephalograms. %26lt;br%26gt;Conclusions: There are statistically-significant differences in measurements produced using a traditional manual analysis, a direct digital analysis or a 3D CT-derived cephalometric analysis of orthodontic patients. These differences are, on average, small but because of individual variation, may be of considerable clinical significance in some patients. (Aust Orthod J 2012; 28: 232-239)
- 出版日期2012-11
