科研之友
微信
新浪微博
Facebook
分享链接
摘要
A simulation tool has been developed to predict sulphuric acid aerosol formation in typical industrial absorption processes for gas cleaning. The underlying model comprises homogeneous nucleation and the growth of a polydisperse droplet collective under the special circumstances of a gas-liquid contact device where heat and mass transfer processes between the bulk phases take place simultaneously. The model is applied to a hot flue gas (200 degrees C) with sulphuric acid concentrations between 5 and 100 mg m(-3) (STP) (STP: standard temperature and pressure). The simulation yields high droplet number concentrations up to 10(16) m(-3) especially for low gas inlet concentrations of sulphuric acid (5 mg m(-3) (STP)), and very small droplet sizes in the range 20-100 nm. The droplet number concentrations decrease and the droplet sizes increase with increasing sulphuric acid inlet concentrations. It is shown that small droplets (< 20 nm) need relatively high supersaturation for growing. If the saturation in the absorption equipment is not high enough the droplets partially re-evaporate but do not vanish due to the extremely low vapor pressure of concentrated sulphuric acid. The resulting size distributions of the aerosol droplets are not very sensitive with respect to the nucleation model used. This is demonstrated by comparing nucleation models with and without hydrate formation. The new simulation tool allows an estimate of the true sulphuric acid removal efficiency of absorption processes which is often not more than 50% due to aerosol formation. In general, the simulation results enable a deeper insight in the mechanisms of aerosol formation and behavior in absorption processes.
- 出版日期2010-12
