科研之友
微信
新浪微博
Facebook
分享链接
摘要
Fully aromatic polyamide thin-film composite (TFC) membranes are the industry standard for membrane-based desalination. Due to the extensive application of TFC membranes to treat feed waters of widely varying composition, new methods are needed to modulate the water permeability, water-solute selectivity, and surface charge of the polyamide selective layer. In this study, the quenching of residual acyl-chloride groups in nascent polyamide films is performed using amine, ammonia, and alcohol solutions, including common alcohol solvents such as methanol and ethanol. Membrane transport characterization in reverse osmosis demonstrates that quenching can substantially increase water permeability. For example, quenching in ammonium hydroxide resulted in water permeability of 2.50 L m(-2) h(-1) bar(-1), which was 2.8 times greater than that for waterquenched control membranes, paired with a small decrease in sodium chloride rejection from 99.7% to 99.3%. By using different quenching solutions, quenching resulted in a range of water permeabilities (0.15-2.50 L m(-2) h(-1) bar(-1)) and water-salt selectivities (98.4-99.7% salt rejection), with performance falling along a previously proposed permeability-selectivity trade-off. Transport behavior and surface characterization indicate that chemical reactions occur to form amides and esters during quenching. Additionally, quenching decreased the carboxyl group density from 25.5 sites/nm(2) for water-quenched control membranes to 11.8 sites/nm(2) for membranes quenched in ammonium hydroxide. Taken together, the results demonstrate that acylchloride quenching provides a novel route to alter the surface charge in addition to water permeability and water-salt selectivity. Potential ways to further optimize the method are discussed.
- 出版日期2017-8-1
