Development of a High-Precision Touch-Trigger Probe Using a Single Sensor dagger

作者：Li, Rui Jun^*; Xiang, Meng; He, Ya Xiong; Fan, Kuang Chao; Cheng, Zhen Ying; Huang, Qiang Xian; Zhou, Bin

来源：Applied Sciences-Basel, 2016, 6(3): 86.

DOI：10.3390/app6030086

• stiffness
• quadrant photo detector
• coordinate measuring machine
• touch-trigger probe

To measure various components with nano-scale precision, a new high-precision touch-trigger probe using a single low-cost sensor for a micro-coordinate measuring machine (CMM) is presented in this paper. The sensor is composed of a laser diode, a plane mirror, a focusing lens, and a quadrant photo detector (QPD). The laser beam from the laser diode with an incident angle is reflected by the plane mirror and then projected onto the quadrant photo detector (QPD) via the focusing lens. The plane mirror is adhered to the upper surface of the floating plate supported by an elastic mechanism, which can transfer the displacement of the stylus's ball tip in 3D to the plane mirror's vertical and tilt movement. Both motions of the plane mirror can be detected by respective QPDs. The probe mechanism was analyzed, and its structural parameters that conform to the principle of uniform sensitivity and uniform stiffness were obtained. The simulation result showed that the stiffness was equal in 3D and less than 1 mN/mu m. Some experiments were performed to investigate the probe's characteristics. It was found that the probe could detect the trigger point with uniform sensitivity, a resolution of less than 5 nm, and a repeatability of less than 4 nm. It can be used as a touch-trigger probe on a micro/nano-CMM.

• 出版日期2016-3
• 单位合肥工业大学