Mechanical alloying of carbon nanotube and Al6061 powder for metal matrix composites

作者：Wu Yufeng; Kim Gap Yong^*; Russell Alan M

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2012, 532: 558-566.

DOI：10.1016/j.msea.2011.10.121

• Carbon nanotube
• Mechanical alloying
• Metal matrix composite
• Length distribution

Mechanical alloying has been widely utilized to break down the clustered CNTs for incorporation in the metal matrix composites. However, the breakage of CNTs during the ball milling process degrades their effectiveness. Due to the challenges in collecting the CNTs for measurement, quantitative study of CNT breakage has been difficult. In this study, the CNTs with Al6061 powder were mechanically alloyed with high energy milling equipment. The CNTs from the surface of mechanically alloyed particles were collected and measured. Due to the difficulty in obtaining the CNTs embedded inside the particles, a mathematical model has been developed to predict the overall CNT length distribution in the composite. Significant CNT breakage occurred during the initial phase of the mechanical alloying due to the crushing of the clusters. The model predicted that no further change occurred in the overall CNT length during time greater than 1 h of mechanical alloying because most of the CNTs had already become embedded within the particles and were thus protected from further milling media impacts. A faster dispersion of CNTs and lower particle fracturing rate may help preserve the original CNTs.

• 出版日期2012-1-15