Deformation mechanisms during superplastic testing of Ti-6Al-4V-0.1B alloy

作者：Roy Shibayan; Suwas Satyam^*

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2013, 574: 205-217.

DOI：10.1016/j.msea.2013.03.013

• Ti-6Al-4V-0.1B alloy
• Superplasticity
• Microstructure
• Texture
• Boundary sliding
• Cavitation

Superplastic tensile tests on warm rolled and optimally annealed boron modified alloy Ti-6Al-4V-0.1B at a temperature of 850 degrees C and initial strain rate of 3 x 10(-4) s(-1) results in a higher elongation (similar to 500%) compared to the base alloy Ti-6Al-4V (similar to 400%). The improvement in superplasticity has been attributed to enhanced contribution from interfacial boundary sliding to the overall deformation for the boron modified alloy. The boundary sliding was facilitated by the starting microstructure which predominantly contains small equiaxed primary a grains with narrow size distribution. Dynamic processes such as coarsening and globularization of primary a phase occur under the test condition but do not significantly contribute to the observed difference in superplasticity between the two alloys. In spite of cavitation takes place around the TiB particles during deformation, they do not cause macroscopic cracking and early fracture by virtue of the cavities being extremely localized. Localized cavitation is found to correlate with increased material transfer due to faster diffusion.

• 出版日期2013-7-1