Development of half-cells with sulfonated Pt/Vulcan catalyst for PEM fuel cells

作者：Xia Yuzhen; Thi Thao Nguyen; Fontana Sebastien; Desforges Alexandre; Mareche Jean Francois; Bonnet Caroline; Lapicque Francois^*

来源：Journal of Electroanalytical Chemistry, 2014, 724: 62-70.

DOI：10.1016/j.jelechem.2014.04.007

• PEM fuel cells
• Hot-pressing conditions
• Nafion (R) distribution
• Sulfonated Pt catalyst
• Porosity resistance
• Half-cells

Half-cell is an ex situ device generally used in fuel cell investigations. The present work is related to half-cell investigations of a particular catalyst for polymer electrolyte membrane (PEM) fuel cells, namely Pt/Vulcan catalyst grafted with 5 wt.% polystyrene sulfonate (PSSA). It was found that the behavior of the half-cell to be immersed in a sulfuric solution was influenced by the hot-pressing conditions in the preparation process: optimum hot-pressing conditions had to be searched for improved, reliable performance of half cells. A stable Naflon (R) membrane interface on the catalytic layer (CL) was obtained at 135 degrees C, 40 bars for 6 min. Otherwise, owing to the ion-exchange properties of the PSSA graft, electrodes were prepared with lower amounts of Naflon (R) and the effect of Naflori introduction in the preparation was discussed: test electrodes mounted in half-cell had either 0.25 or 0.50 mg cm(-2) Naflon (R) dispersed in CL, or with 0.50 mg cm(-2) deposited on CL surface. Their performances for oxygen reduction reaction (ORR) were studied using linear voltammetry (LV) and electrochemical impedance spectroscopy (EIS). Cyclic voltammetry was used for determination of the electrochemical surface area (ECSA) of each electrode. It has been shown that fresh electrodes with 0.50 mg cm(-2) Naflon (R) dispersed in CL exhibit promoted behavior in ORR. However, the GDE prepared with Naflon%26apos; deposition on CL surface exhibits the best resistance to ageing tests performed by potential cycling between 0 and 1.2 V/NHE, as revealed by ECSA measurements.

• 出版日期2014-6-15