Aerosol based direct-write micro-additive fabrication method for sub-mm 3D metal-dielectric structures

作者：Rahman Taibur^*; Renaud Luke; Heo Deuk; Renn Michael; Panat Rahul

来源：Journal of Micromechanics and Microengineering, 2015, 25(10): 107002.

DOI：10.1088/0960-1317/25/10/107002

• aerosol jet printing
• micro-additive manufacturing
• additive manufacturing
• 3D antennas
• chip-to-chip communication
• wearable devices
• Internet of Things (IoT)

The fabrication of 3D metal-dielectric structures at sub-mm length scale is highly important in order to realize low-loss passives and GHz wavelength antennas with applications in wearable and Internet-of-Things (IoT) devices. The inherent 2D nature of lithographic processes severely limits the available manufacturing routes to fabricate 3D structures. Further, the lithographic processes are subtractive and require the use of environmentally harmful chemicals. In this letter, we demonstrate an additive manufacturing method to fabricate 3D metal-dielectric structures at sub-mm length scale. A UV curable dielectric is dispensed from an Aerosol Jet system at 10-100 mu m length scale and instantaneously cured to build complex 3D shapes at a length scale < 1 mm. A metal nanoparticle ink is then dispensed over the 3D dielectric using a combination of jetting action and tilted dispense head, also using the Aerosol Jet technique and at a length scale 10-100 mu m, followed by the nanoparticle sintering. Simulation studies are carried out to demonstrate the feasibility of using such structures as mm-wave antennas. The manufacturing method described in this letter opens up the possibility of fabricating an entirely new class of custom-shaped 3D structures at a sub-mm length scale with potential applications in 3D antennas and passives.

• 出版日期2015-10