科研之友
微信
新浪微博
Facebook
分享链接
摘要
Poly(ethylene terephthalate) (PET) fibers were prepared from entangled solutions through high-temperature electrospinning using phenol as the solvent (melting point, 40.5 degrees C). A continuous process of producing bead-free fibers can be obtained at the lowest spinning temperature of 80 degrees C and the maximum electrospinning concentration of 36 wt.%. Fiber diameter decreased with increasing spinning temperature, but increased with increasing PET concentration. However, the limited processing window at high temperatures only exerted minimal effects. The differential scanning calorimetry heating trace of the as-spun fibers showed the existence of crystallization exotherm with an enthalpy much lower than that of the subsequent melting endotherm. This result suggested that the as-spun fibers were not in the amorphous state. Aligned fibers with a smaller diameter than random fibers collected by a stationary plate were obtained using a rotating disc collector. Structural characterization of the aligned fibers was performed using 2D wide-angle (WAXS) and small-angle X-ray scattering (SAXS) with synchrotron radiation sources. Aside from the isotropic amorphous phase, the as-spun fibers possessed a major oriented non-crystalline (ON) phase together with a trace of triclinic crystallites as revealed by the weak 1st layer (0 (1) over bar1) reflection. The radial average intensity profile showed that the amount of amorphous phase was approximately 91%. The meridional SAXS slice showed no scattering peak, whereas an equatorial streak was observed. The aligned fibers were subjected to stepwise annealing up to a temperature of 270 degrees C. The structural evolution of the unconstrained PET fibers was investigated. A three-phase model consisting of amorphous and non-amorphous (ON and triclinic) phases was used to account for the structural variation.
- 出版日期2014-3
