Methane cracking using Ni supported on porous and non-porous alumina catalysts

作者：Amin Ashraf M; Croiset Eric^*; Constantinou Crystle; Epling William

来源：International Journal of Hydrogen Energy, 2012, 37(11): 9038-9048.

DOI：10.1016/j.ijhydene.2012.02.001

• Hydrogen
• Methane cracking
• Nickel catalyst

Porous and non-porous alumina catalysts were used as nickel supports to catalyze methane cracking. Different operating parameters were studied in a thermal gravimetric analyzer, including methane and hydrogen partial pressures, temperature and flow rate. During CH4 cracking, carbon builds up on the catalyst surface and therefore the catalyst requires periodic regeneration. Cycling tests were performed, using air during the regeneration phase to burn off the carbon. The results showed that the non-porous catalyst performed better than the porous catalyst in terms of cracking during the first cycle. Full regeneration of the catalysts by oxidizing the deposited carbon was achieved at 550 degrees C, while oxidation was very slow at 500 degrees C. After full regeneration, the performance of the porous catalyst became considerably better than the non-porous. The porous catalyst kept its activity for 24 cracking/regeneration cycles, while the non-porous catalyst lost half of its activity by the second cracking cycle and almost all of its activity after six cycles. NiAl2O4 formation and Ni sintering caused the non-porous catalyst activity loss. TPO results showed that two carbon types were deposited on the catalysts, namely C beta and C gamma, where CO is more active than C gamma.

• 出版日期2012-6