科研之友
微信
新浪微博
Facebook
分享链接
摘要
Adhesive joints are normally subjected to different working conditions in their service life. This may involve both static and cyclic loadings. In many instances, a combination of various loading conditions occurs that can be further provoked by exposure to hostile environments. This, in turn, leads to the need to characterize the joint behavior under different combinations of working conditions. Extensive experimental tests are needed in order to evaluate the joint performance under such variable working conditions. This implies the development of low cost and efficient test technique, the one that is simple and reduces the operator time as well. With this objective in mind, a novel technique in mechanical evaluation of adhesive joints was developed in the present work. Alternative monotonic and variable-amplitude cyclic loads were applied on the same double cantilever beam (DCB) specimens under cleavage mode. DCB specimens were made from aluminum bars joined together by a two-part toughened structural adhesive. On one face, a series of crack detection sensors were bonded to control the test machine for switching between monotonic and cyclic loadings. The test machine had two aligned hydraulic actuators which applied bending forces on the upper and lower arms of the DCB specimen. The effects of test frequency and applied load history were also investigated within a range of 4-20 Hz for a nominal adhesive thickness of 0.5 mm. The fatigue performance of each configuration was represented by a power-law relationship and was compared for different test conditions. The test results revealed that the fatigue damage occurred at relatively lower load levels (35%) when compared with monotonic fracture load. The power-law constants for the tested adhesive were influenced by test frequency but were not sensitive to loading order.
- 出版日期2011
