A physically-based constitutive model for SA508-III steel: Modeling and experimental verification

作者：Dong, Dingqian; Chen, Fei^*; Cui, Zhenshan

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2015, 634: 103-115.

DOI：10.1016/j.msea.2015.03.036

• SA508-III steel
• Work hardening
• Dynamic recrystallization
• Flow stress
• Forging

Due to its good toughness and high weldability, SA508-III steel has been widely used in the components manufacturing of reactor pressure vessels (RPV) and steam generators (SG). In this study, the hot deformation behaviors of SA508-III steel are investigated by isothermal hot compression tests with forming temperature of (950-1250)degrees C and strain rate of (0.001-0.1)s(-1), and the corresponding flow stress curves are obtained. According to the experimental results, quantitative analysis of work hardening and dynamic softening behaviors is presented. The critical stress and critical strain for initiation of dynamic recrystallization are calculated by setting the second derivative of the third order polynomial. Based on the classical stress-dislocation relation and the kinetics of dynamic recrystallization, a two-stage constitutive model is developed to predict the flow stress of SA508-III steel. Comparisons between the predicted and measured flow stress indicate that the established physically-based constitutive model can accurately characterize the hot deformations for the steel. Furthermore, a successful numerical simulation of the industrial upsetting process is carried out by implementing the developed constitutive model into a commercial software, which evidences that the physically-based constitutive model is practical and promising to promote industrial forging process for nuclear components.

• 出版日期2015-5-14
• 单位上海交通大学