Nanocrystalline nickel films with lotus leaf texture for superhydrophobic and low friction surfaces

作者：Shafiei Mehdi^*; Alpas Ahmet T

来源：Applied Surface Science, 2009, 256(3): 710-719.

DOI：10.1016/j.apsusc.2009.08.047

• Nanocrystalline nickel
• Surface nanotexturing
• Lotus leaf
• Superhydrophobicity
• Friction

Nanostructured Ni films with high hardness, high hydrophobicity and low coefficient of friction (COF) were fabricated. The surface texture of lotus leaf was replicated using a cellulose acetate film, on which a nanocrystalline (NC) Ni coating with a grain size of 30 +/- 4 nm was electrodeposited to obtain a self-sustaining film with a hardness of 4.42 GPa. The surface texture of the NC Ni obtained in this way featured a high density (4 x 10(3) mm (2)) of conical protuberances with an average height of 10.0 +/- 2.0 mu m and a tip radius of 2.5 +/- 0.5 mu m. This structure increased the water repellency and reduced the COF, compared to smooth NC Ni surfaces. The application of a short-duration (120 s) electrodeposition process that deposited "Ni crowns'' with a larger radius of 6.0 +/- 0.5 mu m on the protuberances, followed by a perfluoropolyether (PFPE) solution treatment succeeded in producing a surface texture consisting of nanotextured protuberances that resulted in a very high water contact angle of 156 degrees, comparable to that of the superhydrophobic lotus leaf. Additionally, the microscale protuberances eliminated the initial high COF peaks observed when smooth NC Ni films were tested, and the PFPE treatment resulted in a 60% reduction in the steady-state COFs.

• 出版日期2009-11-15