科研之友
微信
新浪微博
Facebook
分享链接
摘要
Electrospinning is a powerful method for preparing porous materials that can be applied as biomedical materials for implantation or tissue engineering or as scaffolds for 3D cell culture experiments. However, this technique is limited in practical applications because the pore size of 3D scaffolds directly prepared by conventional electrospinning is usually less than several tens of micrometres, which may not be suitable for 3D cell culture and tissue growth. To allow for satisfactory 3D cell culture and tissue engineering, the pore size of the scaffold should be controllable according to the requirement of the specific cells to be cultured. Here, we show that layer structured scaffolds with pore sizes larger than 100 pm can be obtained by stacking meshes prepared by direct writing using the near-field electrospinning (NFES) technique. In the study, we prepared composite scaffolds made of polycaprolactone (PCL) and hydroxyapatite (HAp) via the above-mentioned method and tested the effectiveness of the novel scaffold in cell culture using mouse pre-osteoblast cells (MC3T3-E1). The pore size and the degradability of the PCL/HAp scaffolds were characterized. The results showed that the average pore size of the scaffolds was 167 mu m, which was controllable based on the required application; the degradation rate was controllable depending on the ratio of PCL to HAp. The biocompatibility of the scaffolds in vitro was studied, and it was found that the scaffolds showed no toxicity and that the cells could effectively attach, proliferate, and differentiate in the 3D skeleton of the scaffolds. Our studies showed that a simple modification of the preparation procedure can lead to a new way to fabricate novel layer-structured 3D scaffolds with controllable structures and pore sizes suitable for practical applications in implantation, tissue engineering and 3D cell culture.
- 出版日期2018-5-1
- 单位西北工业大学
