Application of rapid solidification powder metallurgy processing to prepare Cu-Al-Ni high temperature shape memory alloy strips with high strength and high ductility

作者：Vajpai S K^*; Dube R K; Sangal S

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2013, 570: 32-42.

DOI：10.1016/j.msea.2013.01.063

• Copper-based shape memory alloys
• High temperature shape memory alloys
• Powder metallurgy processing
• Cu-Al-Ni SMA

Cu-Al-Ni high temperature shape memory alloy (HTSMA) strips were successfully prepared from rapid solidified water atomized Cu-Al-Ni pre-alloyed powders via hot densification rolling of unsheathed sintered powder preforms. Finished heat-treated Cu-Al-Ni alloy strips had fine-grained structure, average grain size approximately 16 mu m, and exhibited a combination of high strength and high ductility. It has been demonstrated that the redistribution of nano-sized alumina particles, present on the surface as well as inside the starting water atomized Cu-Al-Ni pre-alloyed powder particles, due to plastic deformation of starting powder particles during hot densification rolling resulted in the fine grained microstructure in the finished SMA strips. The finished SMA strips were almost fully martensitic in nature, consisting of a mixture of beta(1)%26apos; and gamma(1)%26apos; martensite. The average fracture strength and fracture strain of the finished SMA strips were 810 MPa and 12%, respectively, and the fractured specimens exhibited primarily micro-void coalescence type ductile nature of fracture. Finished Cu-Al-Ni SMA strips exhibited high characteristic transformation temperatures and an almost 100% one-way shape recovery was obtained in the specimens up to 4% applied deformation pre-strain. The retained two-way shape memory recovery increased with increasing applied training pre-strain, achieving a maximum value of 16.25% at 5% applied training pre-strain.

• 出版日期2013-5-15