科研之友
微信
新浪微博
Facebook
分享链接
摘要
Low temperature plasma nitriding of stainless steels improves tribological properties and pitting resistance, but it can activate anodic dissolution in acidic solutions. This work aimed at determining how anodic behaviour, can be affected by nitrogen present in the steel. The electrochemical behaviour of AISI 316L steel after nitriding at 415 degrees C (with up to 17 at.% N) was examined in solutions of 0.1 M Na2SO4 + 0.4 M NaCl acidified down to pH 2.4. An antimony microelectrode was used to measure pH close to the sample surface. It was found that the nitrided layer was resistant to pitting corrosion at all pH's, but at pH below about 3.5 anodic currents were higher than those on untreated steel. For nitrided steel the near-surface pH was increasing when anodic current was rising in the active region, evidently due to binding of protons into NH4+. Nitrided steel underwent reactivation during reverse cathodic sweeps which is characteristic of low content of chromium oxide in surface film. Injection of NH4OH into the solution improved the passivation. Thermodynamic data indicated that the accompanying pH rise enabled the formation of Fe3O4, Fe2O3, Cr2O3, FeCr2O4, NiFe2O4, MoO42- and NO2-. It is suggested that the pitting resistance of nitrided steel results from an easy repassivation of incipient pits due to the formation of the above species.
- 出版日期2013-8-1
