Preparation and characterization of alumina-zirconia composite material with different acid ratios by the sol-gel method

作者：Ergu Ozgecan Barlay^*; Guru Metin; Cabbar Canan

来源：Central European Journal of Chemistry, 2008, 6(3): 482-487.

DOI：10.2478/s11532-008-0047-y

• alumina-zirconia composite material
• sol-gel method
• BET
• porosity

Alumina-zirconia composite materials were produced with different acid ratios by the sol-gel method using aluminum isopropoxide and zirconium chloride. The composites were produced by changing acid/alkoxside ratio in alumina. The composite materials were calcinated at 600 degrees C, 900 degrees C and 1300 degrees C. The effects of acid concentration and calcination temperature on the surface area and pore radius were determined from the nitrogen adsorption isotherm at 77 K. The density of the composites was also measured. The minimum density of produced material was recorded as 1.35 g cm(-3) at an acid/alkoxside ratio of 0.2. The highest specific surface area and pore diameter of the lightest material are 191.86 m(2) g(- 1) and 18.4 angstrom, respectively. Although pore diameter and specific surface area are not changed at any of the experimental temperatures which were tested by decreasing acid/alkoxside ratio, the density is slightly increased. However, it was observed that the calcination temperature significantly affects the surface area and density of the material.

• 出版日期2008-9