Direct methanol fuel cell performance of sulfonated polyrimide membranes

作者：Hu Zhaoxia; Ogou Takahiro; Yoshino Makoto; Yamada Otoo; Kita Hidetoshi; Okamoto Ken Ichi^*

来源：Journal of Power Sources, 2009, 194(2): 674-682.

DOI：10.1016/j.jpowsour.2009.06.086

• Direct methanol fuel cells
• Sulfanated polyimides
• Methanol crossover
• Water crossover

Sulfonated polyimides (SPIs) derived from 1,4,5,8-naphthalene tetracarboxylic dianhydride, 4,4'-bis(4-aminophenoxy) biphenyl-3,3'-disulfonic acid and hydrophobic aromatic diamines showed the much lower methanol permeability and the lower proton conductivity than Nafion 112. The performance and the water and methanol crossover for direct methanol fuel cells (DMFCs) with the SPI membranes were investigated in comparison with Nafion membranes. The methanol and water fluxes increased significantly with increasing load current density for Nafion membranes but not for the SPI membranes, indicating that they were controlled by both the electro-osmotic drag and the molecular diffusion for the former but by only the molecular diffusion for the latter. These resulted in the much better DMFC performance for the SPIs than Nafion membranes especially at high methanol feed concentrations. The Faraday's efficiency and overall DMFC efficiency at 60 degrees C and 200 mA cm(-2) for SPI membrane with IEC of 1.51 meq g(-1) were 75% and 21 %, respectively, at 5 wt.% methanol feed concentration, and 36% and 9.5%, respectively, at 20 wt.% methanol concentration. They were about two times and three times higher at 5 wt.% and 20 wt.% methanol concentrations, respectively, than those for Nafion 112. The short-term durability test for 300 h at 60 degrees C revealed no deterioration in the DMFC performance. The SPI membranes have high potential for DMFC applications at mediate temperatures (40-80 degrees C).

• 出版日期2009-12-1