科研之友
微信
新浪微博
Facebook
分享链接
摘要
The purpose of this paper is mainly to develop a method to use the Taguchi method with the L-18 (21 x 37) orthogonal array to obtain an optimal geometrical design of the vertical probing needle and base on various criteria to minimize the stress on the probing needle during wafer-level probing test. Furthermore, importance of the factors on the probing mark area ratio was also ranked. The results shows that as probe length, offset, and lower die gap increase, stress on the probing decrease. On the contrary, vertical probe bends decrease, stress on the probe increase. Furthermore, the body of vertical probe with rectangle cross-section is better than square and circular sharp.
- 出版日期2017
