科研之友
微信
新浪微博
Facebook
分享链接
摘要
Purpose - The purpose of this paper is to explore the use of binder jetting to fabricate high-purity copper parts. The ability to fabricate geometrically complex copper shapes would have implications on the design and manufacture of components for thermal management systems and structural electronics. Design/methodology/approach - To explore the feasibility of processing copper via binder jetting, the authors followed an established material development process that encompasses powder selection and tuning process parameters in printing and thermal cycles. Specifically, the authors varied powder size and sintering cycles to explore their effects on densification. Findings - Three differently sized copper powders were successfully printed, followed by sintering in a reducing atmosphere. It was found that a 15-mu m-diameter powder with a sintering cycle featuring a 1,080 degrees C maximum temperature provides the most dense (85 per cent) and pure (97 per cent) final copper parts of the parameters tested. Research limitations/implications - Due to powder-based additive manufacturing techniques' inherent limitations in powder packing and particle size diameter, there are difficulties in creating fully dense copper parts. To improve thermal, electrical and mechanical properties, future work will focus on improving densification. Originality/value - The paper demonstrates the first use of binder jetting to fabricate copper artifacts. The resulting copper parts are denser than what is typically found in binder jetting of metal powders (without infiltration); significant opportunity remains to further optimize the manufacturing process by introducing novel techniques to tailor the material properties for thermal/electrical applications.
- 出版日期2015
- 单位Virginia Tech; 美国弗吉尼亚理工大学(Virginia Tech)
