Difference in the thickness of mouthguards fabricated from ethylene-vinyl acetate co-polymer sheets with differently arranged v-shaped grooves

作者：Takahashi Mutsumi^*; Koide Kaoru; Mizuhashi Fumi

来源：Journal of Prosthodontic Research, 2013, 57(3): 169-178.

DOI：10.1016/j.jpor.2013.01.004

• Mouthguard
• Thickness
• Shape of the sheet
• Ethylene-vinyl acetate co-polymer sheet

Purpose: To investigate the form of mouthguard sheets that best retains its thickness. Methods: Mouthguards were molded using ethylene-vinyl-acetate (EVA) sheets and a suction-type molding device. Five sheet conditions were compared. These were I-N (Incisal part of the cast positioned at the center Normal sheet), I-H (Incisal part positioned at the center Horizontal v-shaped groove 30 mm from the anterior end), I-C (Incisal part positioned at the center Convexing v-shaped groove toward the back 10-40 mm from the anterior end), C-N (Center part positioned at the center Normal sheet), and C-C (Center part positioned at the center Convexing v-shaped groove toward the back 10-30 mm from the anterior end). Post-molding thickness was determined for the incisal (incisal edge and labial surface) and molar portion (cusp, central groove, and buccal surface). Sheets were heated until they sagged 15-mm below the clamp. Scheffe multivariate comparison was performed to compare changes in post-molding thickness among sheet conditions. Results: Post-molding thickness of mouthguard material differed significantly between the two portions; rates of thickness reduction were smaller for I-C and C-C compared with other conditions. There were no significant differences between I-C and C-C at any measurement points. Conclusion: The present results suggested that thickness reduction of the EVA sheet material after vacuum-forming may be decreased at both incisal and molar portions if the v-shaped groove with a v-shaped cross section was given in the frontal teeth region of the sheet at the apparatus and materials for this study used.

• 出版日期2013-7