A Strip-Type Microthrottle Pump: Modeling, Design and Fabrication

作者：Pecar Borut; Vrtacnik Danilo; Resnik Drago; Mozek Matej; Aljancic Uros; Dolzan Tine; Amon Slavko; Krizaj Dejan^*

来源：Sensors, 2013, 13(3): 3092-3108.

DOI：10.3390/s130303092

• microthrottle pump
• micropump
• numerical simulation
• 3D fully coupled model
• hyperelastic model
• PDMS
• lab on chip
• COMSOL
• fluidics
• optimization

A novel design for a strip-type microthrottle pump with a rectangular actuator geometry is proposed, with more efficient chip surface consumption compared to existing micropumps with circular actuators. Due to the complex structure and operation of the proposed device, determination of detailed structural parameters is essential. Therefore, we developed an advanced, fully coupled 3D electro-fluid-solid mechanics simulation model in COMSOL that includes fluid inertial effects and a hyperelastic model for PDMS and no-slip boundary condition in fluid-wall interface. Numerical simulation resulted in accurate virtual prototyping of the proposed device only after inclusion of all mentioned effects. Here, we provide analysis of device operation at various frequencies which describes the basic pumping effects, role of excitation amplitude and backpressure and provides optimization of critical design parameters such as optimal position and height of the microthrottles. Micropump prototypes were then fabricated and characterized. Measured characteristics proved expected micropump operation, achieving maximal flow-rate 0.43 mL.min(-1) and maximal backpressure 12.4 kPa at 300 V excitation. Good agreement between simulation and measurements on fabricated devices confirmed the correctness of the developed simulation model.

• 出版日期2013-3