科研之友
微信
新浪微博
Facebook
分享链接
摘要
Influence to the steel cord conveyor belt strength has many factors. Conveyor belt splice as the weakest link, should be given more attention. In the previous analysis of single steel cord, by comparing the numerical results of splice deformation and maximum pullout force under tension, both simulation and experiment have a good agreement. Based on this, in this paper, we studied the influence of different factors on the strength of splices under multiple steel cords. In addition to the contact surface between the steel cords and the rubber, we should also pay attention to the rubber problem between adjacent steel cords compared to the single steel cord. And we forced on the simulation analysis of the influence strength of splice by two factors of the position and arrangement of the multiple steel cords. The numerical results show that in the total proportion, the pullout force in the middle position of steel cords was about 52%, however, about 47% in the edge position. For the arrangement of the steel cords, with the number of interval steel cords increases, the pullout force of the steel cord increases as well. However, when the interval steel cords with the same number increases, the increase in pullout force does not agree. The above findings are undoubtedly important for us to understand in depth the factors affecting splice strength. And it is guaranteed that we can obtain the maximum splice tensile strength in the most economical way.
- 出版日期2018
- 单位天津工业大学
