科研之友
微信
新浪微博
Facebook
分享链接
摘要
Poorly cemented sands are mainly located in areas where layers of unconsolidated formations exist. Drilling a borehole in the ground causes stress perturbation and induces tangential stresses on the borehole wall. If the cohesion between sand particles generated by existing cementation is not high enough, the tensile stress concentration may cause grain debonding and, consequently, borehole breakout. In this study a series of solid and thick-walled hollow cylinder (TWHC) laboratory tests was performed on synthetic poorly cemented sand specimens. The applied stresses were high enough to generate breakout on the borehole wall. Simultaneous real-time monitoring and deformation measurement identified the development of localised breakout zones and compaction bands at the borehole wall during the tests. The results from the video recording of the tests showed that a narrow localised zone develops in the direction of the horizontal stress, where stress concentration causes the full breakout in specimens. Dilation occurred at lower confining pressures in TWHC specimens and contracting behaviour was observed during the onset of shear bands at higher pressures. Scanning electron microscopy (SEM) studies showed that sand particles stayed intact under the applied stresses and micro- and macrocracks develops along their boundaries. The SEM imaging was also used to investigate and characterize pre-existing microcracks on the borehole wall developed due to the specimen preparation. It showed that boring the solid specimen in order to produce a TWHC specimen could generate microcracks on the borehole wall prior to testing which affects the process of borehole failure development during the test.
- 出版日期2015-11
