Development of SAW-based multi-gas sensor for simultaneous detection of CO(2) and NO(2)

作者：Lim Chunbae; Wang Wen; Yang Sangsik; Lee Keekeun^*

来源：Sensors and Actuators B: Chemical , 2011, 154(1): 9-16.

DOI：10.1016/j.snb.2010.02.057

• CO(2)
• Multi-gas sensor
• NO(2)
• Reflective delay line
• SAW
• Wireless measurement

A 440MHz wireless and passive surface acoustic wave (SAW)-based multi-gas sensor integrated with a temperature sensor was developed on a 41 degrees YX LiNbO(3) piezoelectric substrate for the simultaneous detection of CO(2), NO(2), and temperature. The developed sensor was composed of a SAW reflective delay lines structured by an interdigital transducer (IDT), ten reflectors, a CO(2) sensitive film (Teflon AF 2400), and a NO(2) sensitive film (indium tin oxide). Teflon AF 2400 was used for the CO(2) sensitive film because it provides a high CO(2) solubility, with good permeability and selectivity. For the NO(2) sensitive film, indium tin oxide (ITO) was used. Coupling of mode (COM) modeling was conducted to determine the optimal device parameters prior to fabrication. Using the parameters determined by the simulation results, the device was fabricated and then wirelessly measured using a network analyzer. The measured reflective coefficient S(11) in the time domain showed high signal/noise (S/N) ratio, small signal attenuation, and few spurious peaks. The time positions of the reflection peaks were well matched with the predicted values from the simulation. High sensitivity and selectivity were observed at each target gas testing. The obtained sensitivity was 2.12 degrees/ppm for CO(2) and 51.5 degrees/ppm for NO(2), respectively. With the integrated temperature sensor, temperature compensation was also performed during gas sensitivity evaluation process.

• 出版日期2011-5-20
• 单位中国科学院声学研究所