科研之友
微信
新浪微博
Facebook
分享链接
摘要
The damage caused by the combination of corrosion and wear processes on the materials that machine elements are produced causes huge losses in several industries such as mineral processing, chemical, petrochemical and power generation. Some devices that operate in harsh environments, such as centrifugal pumps for transportation of caustic liquor used in the industries of production of aluminum, undergo a rapid deterioration of their materials by the coexistence of corrosion and erosion at temperatures around 75 degrees C. The aim of this work is to study new ways for the corrosive-erosive problems confronted by the aluminum and nickel industries. Several coating materials in powder or wire form applied by GMA welding and HVOF thermal spray techniques are compared in erosion and erosion-corrosion tests. Corrosion tests were performed for comparison. A solution of 1 M NaOH was used as a corrosive medium to get the polarization curves The temperature of the electrolyte was 25 degrees C. For pure erosion test, the slurry erosive agent was 4 I of water and an erosive particle concentration of 400 g/l. Particles of ferric oxide, HRC = 40-50 and an average diameter of 600 pm, were used as an erosive agent. The impact angle of 90 degrees was tested, with an impact velocity of the abrasive particles of 31 m/s. Tests were performed for each condition at a time of 2 h at intervals of 20 min. The results show that the best performance was that of the mixed stainless steel and cobalt alloys welded coating even though the general resistance to erosive-corrosive wear significantly favors cermets in relation to the other welded deposits.
- 出版日期2015-4-25
