科研之友
微信
新浪微博
Facebook
分享链接
摘要
We numerically and experimentally evaluate the performance of higher-order mode conversion based on phase plates for 10-mode fibers (10MFs). The phase plates have the phase jump of pi between multiple planes, which match the phase patterns of linearly polarized (LP) modes of 10MF. First, we numerically investigate the effects of the fabrication errors such as the phase-difference error and the slope in the phase jump of the phase plate. The simulation results for the mode conversion to LP11 indicate that such errors make the spatial pattern of the converted beam asymmetric. In order to maintain the symmetric pattern, the phase-difference error is required to be less than +/- 2%, and the ratio of the slope width to the input beam waist should be suppressed to be less than 0.05. Next, we calculate the coupling power efficiencies of the excitation of LP modes in 10MF when the converted beams after the phase plate are launched into 10MF using a lens. As the calculation results, highly accurate adjustment of the input beam waist is required to suppress the crosstalk due to coupling of undesirable LP modes by less than -20 dB. For mode excitation of LP11 or LP12, crosstalk of more than -20 dB is not avoidable even if the input beam waist is carefully adjusted. In contrast, the crosstalk for the mode excitation of LP21 or LP31 is easily suppressed to be less than -20 dB without careful adjustment of the input beam waist. These results suggest that phase plates are not applicable to mode conversion to LP11 and LP12 in 10MF while they are suitable for conversion to LP02, LP21 and LP31. Finally, we experimentally demonstrate conversion from LP01 to LP21 and LP31 modes in 10MF using phase plates. We obtain nearly ideal LP21 and LP31 modes with the small crosstalk due to the coupling of the other undesirable LP modes.
- 出版日期2014-8-25
