科研之友
微信
新浪微博
Facebook
分享链接
摘要
Stress analysis of adhesively bonded joints of sandwich structures is more complex. Only a few research works have studied this subject. The major obstacle is finding the stress distribution at the adhesive layer of sandwich structures under different loading conditions. This paper presents a study on stress distribution at the adhesive joints of the corrugated sandwich structure subjected to three-point bending using the cohesive zone model. Firstly, three cases of sandwich models with different types of glue on both longitudinal and transverse loading directions were calculated using cohesive zone model, and then the corresponding experiments were carried out and compared to prove the FEM results to validate the results through both load-displacement curves and failure deformation modes. Secondly, the cohesive zone model simulation was used to obtain the detailed stress distribution at the bonding joint with the effect of four major geometrical parameters: adhesive layer thickness, corrugated panel thickness, face panel thickness and adhesive joint width. Lastly, the results of stress analysis showed that the stress distribution is not uniform and is highly affected by the bonding joint's geometrical parameters, adhesive layer thickness and adhesive joint width.
- 出版日期2020-1
- 单位大连理工大学
