科研之友
微信
新浪微博
Facebook
分享链接
摘要
The wire electrical discharge machining process (WEDM) allows one to achieved ruled surfaces along intricate contours in hard materials. When one intends to use such a machining process, one has to analyze both the magnitudes of the corners' radii and the corner's angles that are formed between adjoining surfaces. Some experimental research work carried out unveiled the systematic occurrence of machining errors when WEDM is used to obtain outside sharp corners, especially in small thickness workpieces. A permanent bending at the crest of sharp corners, which leads to a substantial deviation from the prescribed geometrical shape, was found. The deviation form depends on the magnetic properties of the workpiece material. The research was focused on establishing a means for characterizing this shape error. Moreover, the influence exerted by certain factors, such as the corner angle and the thickness of the workpiece on the above-mentioned machining error was quantified.
- 出版日期2009-4
