科研之友
微信
新浪微博
Facebook
分享链接
摘要
The flow of a planar jet (sheet) impinging onto a solid flat plate with slip is examined theoretically. The jet is assumed to spread out in a thin layer bounded by a hydraulic jump, and draining at the edge of the plate. In contrast to an adhering jet, a slipping jet does not admit a similarity solution. Taking advantage of the different scaling in each region, series expansions are used in the developing and fully viscous layers, which are matched at the transition point. We show that a slipping film exhibits a singularity in the normal stress at the leading edge of the boundary layer, as opposed to the singularity in velocity and shear stress for an adhering film. The boundary-layer and film heights are both found to decrease with slip relative to a smooth substrate, roughly like root 30x/Re - 2S, whereas the slip velocity intensifies like S root Re/30x with slip. Here, x is the distance along the plate, S is the slip length and Re is the Reynolds number (in units of the jet width). The transition is delayed by slip. Guided by the measurements of Duchesne et al. (Europhys. Lett., vol. 107, 2014, p. 54002) for a circular adhering jet, the hydraulic-jump height and location are determined for a planar jet, and are found to increase with the Froude number (flow rate) like Fr-1/4 and Fr-5/8 respectively, essentially independently of slip length.
- 出版日期2016-12
