A comparative study of pulsed Nd:YAG laser welding and TIG welding of thin Ti6Al4V titanium alloy plate

作者：Gao, Xiao-Long; Zhang, Lin-Jie^*; Liu, Jing; Zhang, Jian-Xun

来源：Materials Science and Engineering A-Structural Materials Properties Microstructure and Processing, 2013, 559: 14-21.

DOI：10.1016/j.msea.2012.06.016

• Ti6Al4V titanium alloy
• Pulsed Nd:YAG laser welding
• TIG welding
• Joint properties

This paper reports on a study aiming at comparing properties of the Ti6Al4V titanium alloy joints between pulsed Nd:YAG laser welding and traditional fusion welding. To achieve the research purpose, Ti6Al4V titanium alloy plates with a thickness of 0.8 mm were welded using pulsed Nd:YAG laser beam welding (LBW) and gas tungsten arc welding (TIG), respectively. Residual distortions, weld geometry, microstructure and mechanical properties of the joints produced with LBW and TIG welding were compared. During the tensile test, with the aid of a high speed infrared camera, evolution of the plastic strain within tensile specimens corresponding to LBW and TIG welding were recorded and analyzed. Compared with the TIC, the welded joint by LBW has the characters of small overall residual distortion, fine microstructure, narrow heat-affected zone (HAZ), high Vickers hardness. LBW welding method can produce joints with higher strength and ductility. It can be concluded that Pulsed Nd:YAG laser welding is much more suitable for welding the thin Ti6Al4V titanium alloy plate than TIG welding.

• 出版日期2013-1-1
• 单位西安交通大学