A simplified model of Passive Containment Cooling System in a CFD code

作者：Jiang X W; Studer E^*; Kudriakov S

来源：Nuclear Engineering and Design, 2013, 262: 579-588.

DOI：10.1016/j.nucengdes.2013.06.010

In this paper, we built up a simplified model of the Passive Containment Cooling System in a CFD code, including a steel plate, a condensing channel and an evaporating channel. In the inner side of the plate, the condensing channel is supposed to be the source of heat transfer into the steel plate. Along the outer side, an evaporating falling film is used to extract the heat from the steel plate. Upward flow of air is also considered along the evaporating film. In the condensing channel, a flow solver based on an asymptotic model of the Navier-Stokes equations at the low Mach number regime and two turbulence models (Buleev's model and Chien's k-epsilon model) are considered. The condensing channel model was used to model the COPAIN test, the computed heat flux and condensation rate were compared with the experimental data. In the evaporating channel, a simplified model developed by Aiello and Ciofalo (2009) was used, which considered the heat and mass balance between the falling film and the ascending air flow. The model was validated for two cases: a dry wall case and a completely wet wall case. In the former case, the results were compared with 20 predictions obtained by using the CFX-4 CFD code. In the latter case, the results were compared with experimental data obtained by Kang and Park. The comparison showed a satisfactory agreement on heat transfer rates, despite some overprediction depending on the air velocity. At the end, the condensing channel model and the evaporating channel model were coupled by the steel plate to establish the complete model for the PCCS. In the absence of relative tests, a case with general parameter values was implemented in the complete model.

• 出版日期2013-9
• 单位中国地震局