A cataluminescence gas sensor based on mesoporous Mg-doped SnO2 structures for detection of gaseous acetone

作者：Weng, Yueyang; Deng, Dongyan; Zhang, Lichun; Su, Yingying; Lv, Yi^*

来源：Analytical Methods, 2016, 8(43): 7816-7823.

DOI：10.1039/c6ay02423h

• PHOTOCATALYTIC ACTIVITY
• SENSING PERFORMANCE
• HIGHLY CRYSTALLINE
• FACILE SYNTHESIS
• FABRICATION
• NANOSHEETS
• HETEROJUNCTIONS
• NANOSTRUCTURES
• DEPOSITION
• NANORODS

In this work, the fabrication of mesoporous magnesium doped tin oxide (Mg-doped SnO2) materials with various doping levels has been achieved through a facile one pot and low cost hydrothermal method without the use of a surfactant. The structure, morphology, chemical states and specific surface area were analyzed in detail. By tuning the amount of Mg doping concentration, a series of Mg-doped SnO2 structures with various morphologies including flower-shaped, nanopolyhedrons, nanocubes, and microcubes were successfully synthesized. It was found that the concentration of the Mg dopant has a significant effect on the crystal structure, surface area and morphology. Moreover, the 1 : 3 Mg-doped SnO2 had a specific surface area as high as 138.6 m(2) g(-1) with a pore size of ca. 3.8 nm. The as-synthesized Mg-doped SnO2 materials and commercial SnO2 powders were used to fabricate cataluminescence gas sensor devices for acetone. It was noted that the CTL sensor based on 1 : 3 Mg-doped SnO2 nanomaterials displayed excellent acetone gas sensing performances such as a fast response time (2 s)/recovery time (25 s), high sensitivity, and good repeatability and selectivity, which indicated that 1 : 3 Mg-doped SnO2 materials would have very promising applications in high performance acetone sensors.

• 出版日期2016
• 单位四川大学