科研之友
微信
新浪微博
Facebook
分享链接
摘要
High Mn steels exhibit an exceptional combination of high strength and large ductility owing to their high strain-hardening rate during deformation. The addition of Al is needed to improve the mechanical performance of TWIP steel by means of the control of the stacking fault energy. In this study, a constitutive modeling approach, which can describe the strain-hardening behavior and the effect of Al on the mechanical properties, was used. In order to understand the deformation behavior of Fe18Mn0.6C and Fe18Mn0.6C1.5Al TWIP steels, a comparative study of the microstructural evolution was conducted by means of transmission electron microscopy and electron backscatter diffraction. The microstructure analysis focused on dislocations, stacking faults, and mechanical twins as these are the defects controlling the strain-hardening behavior of TWIP steels. A comparison of the strain-hardening behavior of Fe18Mn0.6C and Fe18Mn0.6C1.5Al TWIP steels was made in terms of a dislocation density-based constitutive model that goes back to the Kubin-Estrin model. The densities of mobile and forest dislocations are coupled in order to account for the interaction between the two dislocation populations during straining. The model was used to estimate the contribution of dynamic strain aging to the flow stress. As deformation twinning occurred only in a subset of the grains, the grain population was subdivided into twinned grains and twin-free grains. Different constitutive equations were used for the two families of grains. The analysis revealed that (i) the grain size and dynamic recovery effects determine the strain-hardening behavior of the twin-free grains, (ii) the deformation twins, which act as effective barriers to dislocation motion, are the predominant elements of the microstructure that governs the strain hardening of the twinned grains, and (iii) the DSA contribution to strain hardening of TWIP steel is only minor.
- 出版日期2013-9
