Preparation and application of oyster shell supported zero valent nano scale iron for removal of natural organic matter from aqueous solutions

作者：Alipour Vali; Nasseri Simin^*; Nodehi Ramin Nabizadeh; Mahvi Amir Hossein; Rashidi Alimorad

来源：Journal of Environmental Health Science and Engineering, 2014, 12(1): 146.

DOI：10.1186/s40201-014-0146-y

• Humic acid
• Iron supported oyster shell
• Nanoadsorbent
• Natural organic matters
• Adsorption
• Isotherm

Background: In this Research, oyster shell supported zero valent iron nanoparticles were prepared and applied for the removal of natural organic matters (NOMs) from aqueous solutions under different experimental conditions. %26lt;br%26gt;Methods: The nanoadsorbents prepared by wet impregnation method, then characterized using Scanning Electron Microscopy, Energy Dispersive Spectroscopy, X-Ray Fluorescence and BET analysis. Adsorption test was done in a batch reactor and the effects of different parameters such as initial adsorbate concentration, adsorbent dose, adsorption kinetic, pH, and temperature on removal of NOMs (humic acid as the indicator) were studied. %26lt;br%26gt;Results: Results showed that particle size of nanoadsorbent was in the range of 60-83 nm, and surface area and micropore volume as 16.85 m(2)/g and 0.021 m(3)/g, respectively; the main elements of adsorbent were Ca, O, Fe and Na and lime, as high as about 94.25% was the main structural component of the total weight. Produced nanoadsorbent was not soluble in water. It was also shown that by increasing the nanoadsorbent dose from 0.5 to 5 g/100 ml, the removal of humic acid increased from 62.3% to 97.4%. An inverse relationship was found between initial concentration and adsorption capacity, so that a decreasing rate of 33% for humic acid removal was observed by increasing pH from 5 to 10. Temperature increase from 25 degrees C to 40 degrees C, resulted in an increase in humic acid removal from 76.8% to 91.4% and its adsorption on the adsorbent could be better described by Freundlich isotherm (n = 0.016, K-f = 0.013 and R-2 = 0.74). The most fitted adsorption kinetic model was pseudo-second order model. %26lt;br%26gt;Conclusions: The chemical structure of nanoadsorbent was proper and free from harmful substances. Despite the relative good condition of the effective surface, due to the large size of the shell, the overall micropore volume was low. Hence the qualitative characteristics the adsorbent caused the absorption capacity of humic acid to be low (0.96 mg/g).

• 出版日期2014-12-19